Head blueLogoText.gif NCF HelpWiki
Help | StartPage

Difference between revisions of "Router Configuration"

From Support
Jump to: navigation, search
(Router Configuration: wikilinking)
(expand)
Line 7: Line 7:
 
You should be able to configure your router by simply connecting the unit to your computer with an ethernet cable, and accessing the built-in configuration page though your web browser. The address for the user interface, to be entered in your browser's location bar, is often written on the bottom of the unit, or in the router's user manual.
 
You should be able to configure your router by simply connecting the unit to your computer with an ethernet cable, and accessing the built-in configuration page though your web browser. The address for the user interface, to be entered in your browser's location bar, is often written on the bottom of the unit, or in the router's user manual.
  
==Example Configuration Steps==
+
==General router configuration information==
 +
Once you can edit the router's interface enter:
 +
 
 +
#Under "Connection type" (or similar term) Select "PPPoE"
 +
#Under "Account Name", enter in your NCF ID (same format as ''ab123@ncf.ca'')
 +
#Under "Password", enter your DSL password. Enter it in again under "Verify Password" if required
 +
#Under "Service Name", enter a name for your connection, such as "NCF" or leave it blank if you only have one connection.
 +
 
 +
==How to configure some specific router models==
  
 
*[[DLink Router Configuration]]
 
*[[DLink Router Configuration]]

Revision as of 10:58, 29 October 2012

This page deals with configuring a wifi router to work with a DSL modem.

Router Configuration

When a separate router is used with your NCF modem, the typical setup is to put the modem into Bridge mode and have the router do the user authentication. The name of that authentication setting is called "PPPoE."

You should be able to configure your router by simply connecting the unit to your computer with an ethernet cable, and accessing the built-in configuration page though your web browser. The address for the user interface, to be entered in your browser's location bar, is often written on the bottom of the unit, or in the router's user manual.

General router configuration information

Once you can edit the router's interface enter:

  1. Under "Connection type" (or similar term) Select "PPPoE"
  2. Under "Account Name", enter in your NCF ID (same format as ab123@ncf.ca)
  3. Under "Password", enter your DSL password. Enter it in again under "Verify Password" if required
  4. Under "Service Name", enter a name for your connection, such as "NCF" or leave it blank if you only have one connection.

How to configure some specific router models

See also